Spring Compressor Tools Introduction and Use Steps

Introduction: A spring compressor tool is a device that’s designed to compress coil springs on a vehicle’s suspension setup. These tools are used when replacing or maintaining suspension components such as shocks, struts, and springs.

Steps for Using a Spring Compressor Tool:

1. Secure the vehicle: Make sure the vehicle is in a secure position using jack stands and that the suspension component you wish to work on is easily accessible.

2. Loosen and remove the fasteners: Remove the bolts or nuts holding the suspension component in place.

3. Compress the spring: Place the spring compressor tool onto the spring and tighten the compressor bolts, gradually compressing the spring until it’s fully compressed or until it’s possible to remove the component.

4. Remove the component: Once the spring is compressed, remove the bolts or nuts holding the component in place.

5. Release the tool: Release the tension on the spring compressor tool, and remove it from the spring.

6. Install the new component: Install the new suspension component, and tighten the fasteners to the correct torque specification.

7. Repeat steps for the other side: Repeat steps 1-6 for the opposite side of the vehicle.

 Remember to follow the manufacturer’s instructions for the spring compressor tool carefully in order to avoid any accidents or injuries. Be cautious and wear safety glasses and gloves when working with these tools.

article source: https://www.jocentools.com/news/spring-compressor-tools-introduction-and-use-step/

Media Contact
Email: Send Email
Country: China
Website: https://www.jocentools.com/